Item: Happymodel EPW6 900MHz pwm receiver
Antenna connector: IPEX MHF 1/U.FL
6x PWM outputs
RF Frequency: 868MHz(EU), 915MHz(FCC)
Telemetry power: <17dbm
Receiver protocol: PWM or CRSF
Input voltage: +5V DC @ “+” pad
PCB size: 18.5mm x 16mm
Weight: 1 g without antenna
Default firmware version: ExpressLRS v2.0
DIY_900_RX_PWMP(Factory default firmware), PWM receiver via 1~6 PWM outputs
HappyModel_RX_ES900_RX, CRSF Serial receiver via TX and RX
Firmware update via UART or WIFI
1.Supply power to the EPW6 RX, wait until the Green LED on the RX is off, immediately turn off the power, and then repeat again the above steps. When the RX is powered on for the third time, the Green LED light will start to double-flash, which means that the RX enters the binding mode
2.Get into menu of ELRS.LUA V2.0 version from your radio transmitter and then press BIND, the Green LED on the RX module will getting to be solid if bind successfully.
Receiver LED status meanings:
LED solid means bind successful or Connection established; LED double-flash means in bind mode; LED flash slowly means no signal connection from the TX module; LED flash fast means in WIFI hotspot mode, you can connect the WIFI of the RX and upgrade firmware of the RX via visit 10.0.0.1 from the web browser(password: expresslrs)
1. Please understand the product might have some colour difference due to different monitors and scenes.
2. Please allow slight deviation for the measurement data.
1 x Happymodel EPW6 900MHz pwm receiver
1 x 915MHz antenna
1 x 868MHz antenna
3 x 6pin 2.54mm